Modified Bitumen Adhesive

Please refer to the list of states below to determine which SDS applies to your state:
EAST

Alabama, Arkansas, Connecticut, Delaware, Florida, Georgia, Illinois, Indiana, Iowa, Kansas, Kentucky, Louisiana, Maine, Maryland, Massachusetts, Michigan, Minnesota, Mississippi, Missouri, Nebraska, New Hampshire, New Jersey, New York, North Carolina, North Dakota, Ohio, Oklahoma, Pennsylvania, Rhode Island, South Carolina, South Dakota, Tennessee, Texas, Vermont, Virginia, West Virginia & Wisconsin

WEST
California, Washington, Oregon, Arizona, Idaho, Nevada, Utah, Montana, Wyoming, Colorado, New Mexico, Alaska & Hawaii

LionGUARD Modified Bitumen Adhesive is a COLD-APPLIED, SBS POLYMER MODIFIED ASPHALT ADHESIVE, that provides great adhesive and elongation properties. LionGUARD Modified Bitumen Adhesive is available in brush and trowel grades.

USES
LionGUARD Brush-Grade is used to adhere SBS modified bitumen membranes, base and ply sheets. LionGUARD Modified Bitumen Adhesive can also be utilized to adhere conventional BUR ply sheets or fully granulated cap sheets.

LionGUARD Trowel-Grade can be used to make repairs on existing modified applications and flashings on vertical surfaces, i.e. skylights, vents and pipes.

SPECIFICATION
ASTM D-3019 Type III

SURFACE PREPARATION
All surfaces should be free from oil, grease, dirt and loose materials. All BUR surfaces should be patched and repaired with LionGUARD 19 ULTRA Rubberized Flashing Cement and LionGUARD Glass Membrane. Metal surfaces must have all rust and scales removed.

ADVANTAGES
UL approved.
Excellent cure.
Tough, flexible, adhesive and cohesive film.
Excellent water and weather resistance.
Excellent general adhesive.
Excellent lap cement.
Good U.V. resistance.
Complies with current VOC regulations.
Elastomeric, moves with substrate.

APPLICATION
Apply LionGUARD Modified Bitumen Adhesive at a rate of approximately 1 gallon per 100 square feet on horizontal and vertical surfaces; irregular surfaces may require slightly more material. LionGUARD Modified Bitumen Adhesive may be applied by squeegee, roller, brush or trowel.

COVERAGE RATE
Apply LionGUARD Modified Bitumen Adhesive at the rate of 1 gallon per 100 sq. ft.. On porous or irregular surfaces, 2 gallons per 100 sq. ft. may be required.

PHYSICAL PROPERTIES
Weight per Gallon: 8.65
Shear Strength: 18 lbs. / sq. in.
Peel Strength: 10 lbs./lin. in.
Elongation: 200%
Recovery: 80%
Cure Time: 24 to 48 hours @ 77°F
Application Temperatures: 40°F to 100°F

CARE OF TOOLS
Equipment may be thoroughly cleaned after use with mineral spirits, taking necessary precaution when handling combustible materials.

CAUTION
Do not use near open flame. Avoid breathing solvent fumes and prolonged contact with skin. Excessive application may create blistering. Application at temperatures below 40°F may take longer to cure. Do not take internally. If swallowed, do not induce vomiting. Call a physician immediately. Keep out of reach of children. Keep container covered when not in use. Do not thin. Dispose of in an environmentally safe manner. Cover air intakes during application and while drying.

PACKAGING
Available in 5 gallon pails.